Instructions

Double Layer Puff Glitter

TWO PRESS APPLICATION PROCESS

-Do not use any coverings or sheet protectors

-Scrap pieces and patch fabric provided to test press the glitter puff. This is to adjust your temp & time according to results from test press.

Results vary based on hat press.

1. Secure hat TIGHTELY onto your hat press using the cap stretcher

2. Turn on heat 300-302 degrees

3. Pre-press garment for few seconds to remove wrinkles

4. Secure red or green layer onto hat using heat tape. Glitter side facing up towards you.

5. Press this layer at 300-302 degrees for 10-15 seconds at medium to high pressure

6. Let cool for a few seconds

7. REMOVE CLEAR CARRIER SHEET ON THE TOP

1. Align the gold or silver layer on the top of your first layer. Secure tightly- you may not need heat tape because its already sticky

2. Press 300-302 degrees for 18-20 seconds using HEAVY FIRM PRESSURE (almost as high as it goes)

3. Remove clear carrier sheet and hat from press almost immediately to avoid any over heating